ThinkPad X1 Stand (1st Gen X1 Yoga)

thingiverse

Prop up your ThinkPad! Reduce stooping over it on your desk, and your posture and back will be forever grateful! The base is propped up at a 60° angle, lifting the screen 24cm off your desk. You can open the screen from 0 to 180° without worrying about toppling. # Files The only difference between files is the wording on them! Part units are measured in mm. There's no left or right piece; use two pieces or more, as you like. # Safety Don't worry about bending or scratching your laptop. Pressure is applied to the original laptop rubber pads and spread over a large area at the front. Open your screen all 180° or leave it closed – use the keyboard, mouse, and touchscreen without worrying about toppling it over! # Printing No support needed: No | No rafts required. A 100 x 100 mm print bed is sufficient for this print. These parts are lightweight, so you can take them with you. A 15% infill more than strong enough in my testing (Fast Honeycomb infill pattern). The part is designed to be used at its current size. Scale down the model at your own risk; scaling down may cause it not to fit the laptop and increase the chances of toppling.