Thickx180

thingiverse

I gave the design a significant overhaul to accommodate my hardware without excessive reworking. My version is slightly heavier, yet I've been content with its performance so far. The top and bottom plates, plus the skirt, were printed in XT CF-20 material, while the arms were made from standard PLA. Everything functions flawlessly! To secure the components, I used long M3 screws that directly insert into the plastic – it was a surprisingly effective solution. In my last crash, an arm did break, but I'd like to think that wasn't entirely my fault; after all, I was pushing the limits with full throttle while flying inverted straight into a tree trunk.