Thermometer Holder

thingiverse

The person in the photo is clearly an older model. Key changes were made to the backplate thickness and adjustments to the hang hole. Additionally, the upper "jaw" aesthetics were modified to match the rest of the design by chamfering the top edge. A wider cable pass was also created behind the cylindrical part. If you plan to use this item for other purposes, here are some measurements to help determine its suitability: The thermometer's dimensions are as follows: Height: 54 mm Width: 14 mm (thickness of the device) Length: 64 mm (this dimension has little impact on the design) The diameter of the cylindrical part is 15 mm in diameter. The holder is 20 mm wide. Printing time was approximately 27 minutes, using 3.51 meters of PLA filament. Estimated material cost for PLA is around 0.32 euros, based on a calculation from a 200-meter spool priced at 17.99 euros, which works out to approximately 0.08995 euros per meter.