Thermaltake Tower 900 Grommet Bulkhead Insert

prusaprinters

<p>While this is registered a s a remix, it is actually a completely new set of models with STEP files included.</p> <p>There are two versions. The threaded version is designed for use with standard g 1/4 fittings for water cooling. The three small screw holes are threaded to 6-32 (standard computer screws) for clamping into place. This version is highly dependent on the accuracy of your printer. The front plate should snuggly slide through the back plate with no clearance. Most of the time screws will not be needed, but they are included just in case. It also looks awesome with the three screws in. I have had interference with some very large fittings, so if you do add screws, flathead may be needed on the outer screws. I made this as a test piece but found that it worked so well that I decided to included it. Mine does not leak, but water tightness will completely depend on the quality of your prints. Your first layers must be perfect, and the top layer completely clean. any under extrusion or defects will cause issues!</p> <p>The pass through version is setup to use with EWKB or similar bulkhead fittings. Slide the fitting through the front plate and back plate, then screw down the collar. Again, screws may be added, but are not required.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Prusa</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>I3 MK3S</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>.2</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>15</p></div> <p><strong>Notes:</strong></p> <p>I recommend 6 shells vertical for the G 1/4 fitting threads.</p> <p>For front plate, print with largest face down.</p> <p>For back plate, print with screw reinforcement up.</p> <h3>Parts Needed</h3> <p><strong>2x EK-AF Pass-Through G1/4</strong></p> <p><a href="https://www.ekwb.com/shop/ek-af-pass-through-g1-4-black">https://www.ekwb.com/shop/ek-af-pass-through-g1-4-black</a></p> <p><strong>3x Screws</strong></p> <p>6-32, flathead, stainless is recommended</p> <p><strong>Passthrough with EWKB fittings and screws</strong></p> <p><strong>Threaded front with screws and G1/4 fittings</strong></p> <p><strong>Threaded back with screws and G1/4 fittings</strong></p> </p></p></p> Category: Computer