the WhoovShip

thingiverse

You can repurpose the F1, F2, and V1 parts among themselves. However, when working with the F1 hull, you'll need to utilize either the F1 or F2 deck. I personally stick to using two strips of tape on the sides to keep it securely closed. To accommodate the deck, you will have to trim down an E010 frame's ducts. These should fit snugly and seamlessly into place. I employ a "foam template" to mark where to cut my foam, which helps me accurately plan out my cuts. It's worth noting that the ducts on the E010 are slightly thicker than those found on the E010S and E011. Given this, I designed mine with the E010 ducts in mind. As a result, you might need to apply a small amount of hot glue to successfully utilize the E010S and E011 ducts within the deck part. That being said, make sure to only use the E011 duct in the F1 deck as it features a single lift motor on that particular deck. This would essentially reserve your E011 ducts/motors for propulsion purposes. When handling the motormounts, I prefer scaling them up by 1% within the slicer software. This simplifies the process of getting them precisely positioned.