The Ultimate Spool Holder Dry Box Remix

thingiverse

This is a remix of https://www.thingiverse.com/thing:2929701. I like the design but I wanted more clearance underneath the rolls for this silica drybox. https://www.thingiverse.com/thing:3164954 I also made the rollers higher so the rolls do not come off when sliding them on the rod when shifting things around for new rolls/drying silica etc. The roller sides have also been combined into one piece so you do not need to glue the two sides together. It's a little harder to print but not bad with a little support. There are two base rod holders included. One is taller for more clearance underneath if you need it. The one in the main picture is the "not-so-tall" STL. I have added a couple of pictures of the taller one. You do not need to print both! I originally had the tall one printed out but when I installed the Protopasta re-enforcement rings I designed here https://www.thingiverse.com/thing:4321364, The top would not go on anymore. So I made them shorter. So if you plan on using my proto-pasta rings you will need the shorter base rod holders. The taller one worked just fine with a standard roll. The filament guide on the Ender 3 in the picture is located here https://www.thingiverse.com/thing:4370243 I changed the filament ports on the drybox since I took the original pictures. I've replaced the main picture with the new ones. The silver ones were a bit fragile. https://www.thingiverse.com/thing:878919