The Ultimate 3mm and 4mm FlashForge Creator Pro Z-Axis Shims

thingiverse

These are custom designed shims that have been perfectly matched for use with a Flashforge Creator Pro, which was built mid-2015. They are specifically designed for 3mm or 4mm glass bed upgrades of similar size. Instead of leaving a gap around the two bolts, these shims fit snugly around them to avoid problems with the z-axis switch. Both designs clearly show their respective shim heights on the stamps in case you have beds that vary in height. Please take a moment to upload some photos if you choose to make these. Instructions These shims were printed upside down using no bed, as provided. To achieve this result, use settings of 0.2mm, without support structures, and print with 50% infill density, 4 top layers, and 4 bottom layers. If printing in this manner does not work for you, try flipping them over to see if the outcome improves. Printing on the opposite side helps prevent warping or bending of the piece during printing. In the unlikely event that your shims warp or bend during printing, it's an easy fix to apply a little heat using a lighter to adjust the piece. Please don't forget to upload some photos if you do decide to make these.