The Tenacious Tension Holster for OOD Jupiter Nerf Rival Blaster

thingiverse

Pardon the print quality in my photos. You need the Holster body and your choice of tension mechanism to make the holster work properly. UPDATE 9/5/2019 Added - New holster body file, with more material above the tension mechanism for easier blaster release. Molle straps can now be mounted to the back without issues. UPDATE 9/4/2019 Added - Low tension mechanism, mid tension mechanism, and high tension mechanism. High tension mechanism is also included in the initial file. ------------------------------------------------------------------------------------------------------------------- Adjustments will be made over the next week or so. This is a fully functional tension holster for the Out of Darts Jupiter blaster, created by me. Four previous prototypes have been refined to produce this design, which may undergo minor changes. However, it is suitable for my intended purposes despite being a bit tight over the molle buttons (future modification). Instructions: You will need a sacrificial wire hanger or equivalent. You will need a sacrificial Waffle tip dart or equivalent. The .stl file includes two pieces: The holster and the tension mechanism. Clean out holes provided so that the hanger inserts cleanly. Remove the waffle tip from the dart, glue it into the provided hole, and trim excess tip from the inside of the holster. Place the tension mechanism into position. Cut a piece of wire hanger to the length of a full-length dart body. Run the wire hanger piece through the holster (provided hole), tension mechanism (provided hole), and finally rest it in the other side of the holster (provided hole). The holster is complete.