The Teamwolf Special (Rear Side Cutouts) - A Ring Gasket Mount Case for the Teamwolf Zhuque Keyboard

thingiverse

INTRODUCTION: This is a ring gasket mount case for the Teamwolf Zhuque keyboard. This version has rear side cutouts. Another version has front side cutouts. INGREDIENTS: (1) Teamwolf Zhuque plate, PCB, and cord. (2) ring gasket material [I use the following 4mm diameter gasket: https://item.taobao.com/item.htm?spm=a1z09.2.0.0.26402e8dALgGgH&id=613137269072&_u=120rh52ke619] ASSEMBLY INSTRUCTIONS (1) Disassemble your Teamwolf Zhuque keyboard. You will only need the plate, PCB, and cord. (2) Insert gasket material between the plate and PCB. The gasket will not ring the entire perimeter of the plate/PCB. It will only line the top and bottom, but not the sides, so a length of 720 mm or less should be sufficient. (You can either run the gasket material along the entire top and bottom lengths, or at discrete segments, as you prefer.) (3) Lower the assembly into the case, taking care to place the rectangular notch of the cord in the cord holder in the case. The gasket material should be resting on the ledges at the top and bottom of the case; the cord should be sandwiched between the metal prong on the Teamwolf plate and the cord holder. If your print volume is large enough (length ~360mm), then you can print out the "Whole Case" all at once. For those with smaller print volumes, I've divided the case into thirds ("left part," "middle part," and "right part"). TO DO: Implement replaceable cord mod.