The Squall - E3D Titan Aero DUAL 5015 blower mount with hidden bltouch mount for CR10 CR10S

thingiverse

So I was pretty close with the single blower Titan Aero mount, but then I thought why bother. So I went big and did something new. **BLTouch V2.1 + EZABL V1.28 update** I added some extra support under the left fan mount to make printing in the upright orientation (nozzles on the bed) easier with ground up supports only, and I also added a small support under the right fan mount too. Plus, I removed a bump from the carriage plate to make fitting the heat block in easier when installing. **EZABL V1.27 update** I added EZABL to the mount, it's not in the best spot, but there isn't really anywhere else for it to go. It will clear the X axis stepper housing and limit switch, so that's not the problem, but you might struggle to get it far enough over to get a good reading. I printed out the pink one at 0.2@50%+2 Shells. The second fan (right) is offset forward to allow clearance from the filament tension knob. A channel connects the two fans so if one fails, it will also balance the pressure between them. On V2 in a week or so, I'll be adding diffusers on the nozzles, and an offset baffle in the air channel to stop one nozzle from stealing all the airflow. I'll also add better cable management for the bltouch, stepper and fan cables. Any other suggestions, let me know before I merge the new STL. For this reason, this thing is marked as a "work in progress," but it functions absolutely fine on my CR10S. I completely redesigned the air channels and blowers on this model compared to the single 5015 unit allowing for more airflow and less resistance from fan to nozzle.