The Sims Plumbob

thingiverse

A simple 3D model in two parts of the Plumbob from the The Sims games. The original design, was intended to use 6 x 3 mm cilindrical neodymium magnets to keep the two parts together. Also, in order to attatch the finished part to the headband, a hole for a 1.6 mm diameter metal wire was made at the botton. This being said, I will upload these two iterations of the same model: the original one with all the holes and one without the holes. If you do not intent to attatch the Plumbob anywhere, you may only want to print the upper part of the design two times to make a complete one, as these two parts (the upper and lower parts) are simetrical except for the metal wire fitting hole attatchment in the botton part.