The Original Simpsons TV (Remix - more stable and with screws)

thingiverse

A working desktop television that plays videos on an endless random loop. Re-designed this tiny tv to make it stronger and able to open/close the case with screws. These are all the parts you need to print to build the TV. I will write a [build](https://github.com/pwallner/SimpsonsTV) guide based on the original, so stay tuned... #### Parts used for assembly: - 4x Screw acc. DIN7991 M3x12 (full thread) - 4x Nut acc. DIN934 M3. - 1x Raspberry Pi Zero (or W or 2 W) - 1x Waveshare 2.8 640x480 Screen - 1x Adafruit Mono 2.5 W Audio Amplifier - 1x 1.5" 4 ohm 3W Audio Speaker - 1x Micro USB DIP Breakout Board - 1x Micro USB Male Solder Plug - 1x 1k Trim Potentiometer 9.6x9.6mm - 1x Micro Push Button Switch 8x8mm - 22 Gauge Wire Black/Red Pair #### Printing: All of the parts, except the Front, can be printed with minimal infill and no supports. The Front needs supports with minimal infill. There's more information about the print setup over on the build guide.