The Mummy Diorama for Wekster Mini Dude Mummy

myminifactory

Here is the Diorama for @Wekster Mummy. To print without supports, ensure that the parts are set in the correct orientation. Place the wall on its back, flat on the bed. Print the Wall Glyphs with the glyphs facing upwards. The Column will print standing up, while the Column top should be printed standing up with the top on the print bed. The Sarcophagus can be printed just laying flat on its bottom. The Base should be printed facing flat on the bed. All parts are printed at 0.1 layer height except for the wall, which can be printed at a higher layer height since it will be covered by the glyphs. To make room for the Mini Mummy, I've cut it in half so it could fit inside the Sarcophagus. You can place it somewhere else if you prefer. Enjoy printing and painting your Diorama! Don't forget to share your pictures.