The Mummy Diorama

prusaprinters

<p>Here's the Diorama for @Wekster Mummy. Figurine not included</p> <p>It prints without supports, just make sure you set the parts in the correct orientation.</p> <p>Wall should printinglaying flat on its back. Wall Glyphs should be printed with the glyphs facing up. The column will print standing up. Column top should be printed standing up with the top on the print bed. Sarcophagus should print fine just laying flat on its bottom. Base should be printed facing flat on the bed.</p> <p>All printed at 0.1 LH except for the wall that you can print at higher layer height since it's going to be covered by the glyphs</p> <p>I've cut the Mini Mummy in half so it could fit inside the sarcophagus but you can plate it somewhere else if you like.</p> <p>Hope you enjoy printing it and painting it. Please share your pictures.</p>