The Hive - Hurricane Duct for V6 Hotend Remix

cults3d

I was blown away by the design of The Hurricane duct created by @TheSniper, as it was straightforward enough to be printed without supports and effortless to print without any complications right from the very first try. However, I noticed two things that I would really like to modify. Firstly, I wanted the ducts themselves to be a bit closer to the tip of the hotend, and secondly, the hotend fan mount instantly melted on the bottom because it makes contact or very close to making contact with the heater block of the v6 hotend. My solution is to open up that area to allow for better airflow. On top of that, I recommend placing a strip of metal duct tape on the bottom of the fan to move heat away from the plastic. I have had this hotend printing for several weeks now with zero issues and my bridges are performing better than ever. A huge thank you goes out to @TheSniper for the original design! Enjoy and post your creations! If you found my Things useful, treat me to a cup of coffee by using the PayPal button below: Buy me a cup of coffee $3.00 USD Buy me a massive cup of coffee $5.00 USD Give me a caffeine coma $10.00 USD