THE FLOGGER - SPACE HUNTING

cults3d

New model is a space fighter called "THE FLOGGER", a design that evolves the landing gear, with a new concept for zero gravity platforms, this type of model allows it to move within its launch ramp obtaining total adhesion to the ground by its wide surface. It has dihedral wings and a 4-point pivot motor, incorporated in the nozzle; it employs 4 long-range antennas for enemy disturbance on the nose tip, 2 antennas on the fuselage spine for communication with its space station; it also uses retractors to change the dihedral angle of the wings. A traditional cage cockpit offering a wide view to the pilot, 2 short range guns and 2 long range guns. This model is composed of 14 pieces, it should be noted that the cannons should be duplicated in the print to cover the opposite wing, likewise with the cathode sink on the inner rear side of the fuselage, this piece should also be duplicated (see assembly picture). Its dimensions are 200 mm long x 167 mm wide and 100 mm high; without pedestal. It is a model with pedestal for when you want it flying or not, I hope you enjoy this new work, leave me your comments and do not forget I am always ready for any questions! Efran Note: I have uploaded photos of a quick print and there is no problem with the print, I am sure you will get the best finish!