The complete BLTouch/3DTouch guide for Creality printers (CR-10/s,Ender 2,Ender 3) for Auto Bed Leveling UPDATED

thingiverse

28-06-2018 - Users are facing challenges obtaining the Pin 27 adapter board, a workaround is available at http://jonathanlundstrom.me/2017/10/23/cr-10-bltouch-firmware/. 26-06-2018 - Version 3 has been added to address suggested changes in the CR-10/Ender 3 section for clarity. 25-06-2018 - A new version 2 of the guide is available due to issues with v1, it includes more photos and screenshots for installation. This guide aims to provide a simple resource with all necessary information in one place or linked, sections include; Before you start Printers CR-10s /S4/S5/Mini Ender 2 Ender 3/CR-10 Configuring Z offset Start-up GCODE CR-10/s Ender 2 Ender 3 Misc & Extras Remove all boot screens for faster boot times Control ooze while bed levelling runs (Simplify3D) CR-10 stock to CR-10s board This guide uses firmware included in the guide, please use the hyperlink to download this firmware. For CR-10 and Ender 3 users, please use pin 27 instead of 29 as mentioned in the guide. I hope this helps clarify the instructions, if not please leave a comment or contact me directly through my Ender 3 group at https://www.facebook.com/groups/Ender3dp/. Join my new Ender 5 group at https://www.facebook.com/groups/ender5/. This guide uses TH3D Firmware, thank you to TH3D for the awesome firmware. To avoid confusion, users with V2.1 CR-10s boards should follow the same pin out as shown in the v2.0 wiring diagram. I would appreciate it if users could tip a couple of dollars for this guide, but don't worry about it if not. Thank you to those who have already tipped. Looking to buy a Creality product? Purchase one from their brand new factory direct store with improved support and after care system at https://www.creality3dofficial.com?sca_ref=10298.y8aTiPc6FX.