"The Bitter Truth" Fantasy Football Trophy Base Remix

thingiverse

This is a base that was specifically designed for this trophy: https://www.thingiverse.com/thing:3419699 And remixed from this base to make it bigger and fit name plates: https://www.thingiverse.com/thing:3857323 Whatever resolution you printed your football at, use that same resolution on this base or slightly less depending on your preference. The football will go about 1cm deep into the base. I printed both the ball and base at 0.08 and the nameplates were printed at 0.16 with filament switches at layers 15 and 19; 15 from copper to black and 19 from black to copper. I believe I used either 15% or 20% infill which gives it some good weight, but at the expense of filament. Can go lower if you need. Used superglue to adhere them together, just be aware of gas that will leave some white residue, which can be removed very carefully with acetone on a rag/paper towel.