The Bertuccio - A Geometric 60% Keyboard Case

thingiverse

This is a sleek 60% keyboard case with several key features:\r\n\r\nStandard 60% size (e.g., GH60, DZ60) - The interior tray compartment matches the dimensions of a typical 60% plate (i.e., 285.752 mm x 95.252 mm). Note that it may not fit a GK61 plate; instead, you'll need to find a standard 60% plate if using a GK61 PCB. Also, the GK61 PCB is slightly larger than a typical GH60 PCB, so printing the case at 100% scale might be necessary.\r\n\r\nNo standoffs - A 5 mm ledge runs around the inside of the tray compartment where the PCB rests. This means the PCB is not attached to the case in any way. I chose this design for several reasons: First, it allows me to test the bottom-out feel without standoffs; Second, it enables fast case changes by rotating a single PCB through various cases; Third, resting a PCB on standoffs and friction between the case and plate provides sufficient stability while typing.\r\n\r\nNote that I haven't printed this case yet, so its feasibility is unknown. However, printing the Haydee, similar in design to the Bertuccio, mostly worked as intended.