That Craft Place Apothecary Chest Add-Ons

thingiverse

The Apothecaries Chest from https://thatcraftplace.co.uk/products/apothecaries-chest is a fantastic kit but some small printable add-ons can take it to the next level: 1. The door hinge is, quite literally a square peg in a round hole. - Print one each of DoorBearingTop.stl and DoorBearingBottom.stl and fit them over the square nubs on the door. They'll make the door opening much smoother. - The two are slightly different sizes which also prevents the door scraping at the bottom. - You don't want to paint these, so print them in a color that will blend in with the way you're decorating the chest. Paint will stop them rotating freely. 2. The holes for the drawer handles are very large (5.5mm) which rules out using Doll's House ones and there is very little room between the drawer front and the back of the door when it is closed. Two solutions are provided: - DrawPull_JumpRing.stl - print 4 (5 if you want one for the front door too) and then bend a large jump ring (or 1mm thick craft wire) into a D shape and push the flat side down the slit in the narrow portion until it clicks into place. The narrow portion is then a push fit into the holes in the drawer fronts. The D-shaped piece should swing freely in the slot. - DrawPull_D-Ring.stl - use exactly as above, the only difference is that these are sized for use with the "ring" from D-shaped picture hanging hooks which are made from 1.1mm wire and so the hole is slightly larger. 3. Bonus piece really - this fits in the bottom drawer and takes eight 15mm diameter miniature glass bottles - the sort you find full of gems or prills in craft shops. No special instructions for this, just print, paint and drop it in place.