TFT35 V3.0 Extrusion Mount

thingiverse

## PRINT AT YOUR OWN RISK Screen Mount for Biqu TFT35 V3.0 Designed for Mounting on Ender 3 Extrusion Rails. This screen mount was modeled from drawings available to me while out of town, printed with test tolerances since the start. Mounting screws are M3x5 and will require threads to be cut into the plastic when inserted for the first time. ## Revisions: 09/11/19 * Printed left side successfully. Posts are now good. * Added a small lift to the bottom face to position the side over the top of the extrusion. * Enlarged extrusion mounting holes slightly, still able to use factory hardware. * Smaller screen opening was made. * Photos of printed version added before these changes. 09/07/19 * Removed old iterations that were no longer being worked on and weren't correct. * Added versions with sides added and cutouts for USB and SD card. * New photos of the new iterations from both sides and rear were added. 09/06/19 * Post length was adjusted again, both left and right models. * New photo of the left side mount was added. 09/04/19 * Simplified designs were added to get things ironed out before adding more support (case -right mount & case - left mount). * Old files were left in place for now. 8/25/19 * Added support below the case to add rigidity. * Verified with Ender 3 rail drawings to fit. * The bottom face of the case was made taller to allow room for future add-ons and cable attachment. * The upper case was made a bit wider to make room for future add-ons (walls). Future Plans: * Right side mount will be done once specs are verified for the left model. * Close in the back - for both models. This project was possible in big part because of the work done by SwissDeadCow and his modeling of the Biqu TFT35 V3.0.