TFA X-Wing Pilot Helmet - 3D Print Ready 3D print model

cgtrader

UPDATE NOVEMBER 2017 PLEASE DO NOT SCALE THIS DESIGN TO LESS THAN 90% OF ITS ORIGINAL SIZE. THE WALLS ARE A MINIMUM OF 3mm THICK AT FULL SCALE DIMENSION. HOWEVER, WHEN SCALING DOWN BELOW 80%, THE WALLS BECOME SIGNIFICANTLY THIN. IF YOU INSIST ON REDUCING THE MODEL TO THIS EXTENT, IT IS HIGHLY RECOMMENDED THAT YOU USE MULTIPLE SHELLS AND CONSIDER RUNNING IT THROUGH MESHMIXER TO IMPROVE STRUCTURAL SOLIDITY. I WENT WITH A CREATIVE INTERPRETATION OF THE NEW RED/BLOCK DESIGN DEBUTED IN TFA, AND THIS X-WING HELMET RECREATION HOPES TO CARRY OVER THE VISUAL IDENTITY EFFECTIVELY. A TOTAL OF 20+ SEPARATE PARTS IS REQUIRED FOR THIS PROJECT, INCLUDING A COMPLETE, UNALTERED REPLICA OF THE FULL HELMET DESIGN. TO ACCOMMODATE MOST PRINTER MODELS, PARTICULARLY CR-10 TYPE BUILD PLATES, I OPTIMIZED THE CUT LAYOUT. SHOULD YOU FIND THAT YOUR PRINTER HAS TROUBLE PROCESSING THIS DESIGN, PLEASE DO NOT HESITATE TO CONTACT ME DIRECTLY SO THAT I CAN ADJUST THE FILES TO FIT YOUR DEVICE SPECIFICATIONS AND SEND THEM OVER VIA MESSAGE. PLEASE NOTE THE FOLLOWING DIMENSIONS: * FULL X-WING HELMET WIDTH: 31.3CM * EARYTO-EAR DIMENSION: