TF2 Logo Keychain

thingiverse

This is a TF2 logo keychain based on the r/place logo created on Reddit. To achieve the multi color effect, I utilized the 'Change Filament at Z' Cura plugin. My printer settings included a layer height of 0.2mm and a layer width of 0.24mm. The layer count used to switch filament is as follows: Layer 0 - Black Layer 6 - White Layer 8 - White Layer 10 - Orange Layer 13 - Yellow Layer 16 - White To customize this design, you can check and update the colors in your slicer by using different layers. Make sure to use infill greater than 40% for a smooth surface finish. You're free to use this design however you like, just remember to give proper credit.