Textured grip battery compartment for Oculus Rift CV1 Touch controllers

thingiverse

I created this to help with sweaty hands while playing in VR. These completely replace the battery compartment doors. You may need to lower the model by one layer so the whole bottom sits on the build plate. Create a mirrored copy for the second controller. You will likely need to sand down the supported surfaces slightly to get a good fit. I recommend printing in ABS so you can brush acetone on the outside to smooth it. (I recommend against using acetone vapor to reduce the chance of warping when the outside is smooth enough) Add magnets of your choice to the cylinders with pins (two per controller), careful to match the polarity of the original cover. I used 1/8" dia x 1/16" thick disc magnets set in epoxy putty after cutting out the pin.