Tevo Tornado X-Axis Tensioner

thingiverse

I noticed that my Tevo Tornado struggled with attaching and aligning CR-10 or CR-10S X-Axis tensioners properly. The Tornado X-Belt alignment seemed lower and towards the rear than it should have been, off-center from the 2020 extrusion. Considering this issue, I discovered an alternative X-Tensioner that I adapted to fit my Tevo Tornado. So far, it's performing well with good tension and no belt scraping on the tensioner. Only the bracket (ATRM_Bracket_v211) was modified to accommodate the Tevo Tornado. The rest of the parts remained unchanged. I'd like to give credit to the original designer of this tensioner for their work. For more details about hardware, screws, or other information, please refer to the original design. Check the notes below for recommended print settings.