TEVO Tarantula y-axis idler bracket with Go Pro mount

thingiverse

The model prints well when sliced with CURA software, requiring minimal support settings except for overhanging clips. Set supports to "Everywhere" for optimal results, as most parts lay flat on the bed without needing additional support. However, you may need to drill out holes for a tighter fit due to their initial tightness. The camera will be mounted at a level consistent with the bed's height and extended enough to clear the large bed during y-axis printing limits. Print Settings: Printer: Tevo Tarantula Rafts: No Supports: Yes Resolution: 0.2mm Infill: 20% Post-Printing Steps: Drill out holes for a better fit. Design Process: The standard .stl file from the TEVO facebook group was used as a starting point, extended using Tinkercad, and then fused with a Go Pro mount. Unnecessary protrusions were removed to achieve a flat bed print.