Tevo Tarantula Noctua Fan Duct

thingiverse

UPDATE: Improved the design and remixed this again. Still uses the same fans, but the x-carriage, fan duct, and connection are all new, including a wire cover. You can find it here: https://www.thingiverse.com/thing:3139515 This is my Tevo Fan Duct made for use with Noctua fans. I wanted to make my printer as silent as possible, so this is my setup. This is the first model I uploaded, and I hope everything loads correctly. The fan shroud is of my design and allows for the usage of two Noctua 40x40x20 and one 40x40x10 for the heat sink. The x-carriage is a large remix of two different designs: rc_mrk's Tevo Tarantula X-Carriage with Fan and Belt Tensioner (https://www.thingiverse.com/thing:1938505) and fits thingirob's Tevo Tarantula Modular X Car Basic (https://www.thingiverse.com/thing:1438795). I have used this design for some time now, and it works great. Parts list: 2 Noctua NF-A4x20 FLX fans (self-driving screws from the set are used to mount) 1 Noctua NF-A4x10 FLX fan 1 40mm M4 bolt with nut (for belt tensioner) 2 M4x15 bolts for heatsink fan mount to shroud (mount last) 2 M3 screws from original heatsink fan to mount lower part of Fan shroud 2 M4x9 bolts with nuts to mount Shroud to modular x-carriage connection 1 rubber band (I'm using it as a seal that I added around the base of the top two fans, see pictures) One last thing... You may notice a vertical hole on the back of the modular connection. I use it along with an M3 screw to level the hotend. You may not need it, but it's there if you do. Hope you like it!