Tevo Tarantula 5mm idler spacer for Y axis

thingiverse

As about everyone, I was clearly disappointed with the spacers that ended up grinding down due to the pulley's stuck bearing.\r\n\r\nThis spacer is specifically designed to push against the bearing rather than the rotating part, allowing it to reach 20mm when used in a pair. That keeps the acrylic components perfectly parallel.\r\n\r\nThe inside diameter is 5mm, while the side pushing on the pulley measures 7mm and the widest part spans 11mm.\r\nThickness comes in at 5.5mm.\r\n\r\nIt's best to print these spacers in a pair, with a 100% infill and no brim whatsoever.\r\n\r\n**If you're dealing with stuck bearings, simply switch to the provided shorter version, which will leave some play for the pulley to rotate freely.**\r\n\r\nFor the motor side, please check out this set: https://www.thingiverse.com/thing:2491039\r\n\r\nThese spacers are also commonly used in combination with the X-axis rigidity bracket : https://www.thingiverse.com/thing:2491596