Tevo Michelangelo Camera Mount

thingiverse

This camera mount is designed for the Tevo Michelangelo,\r\n\r\nIt features three holes, with two requiring M5 tapping to secure it to the bed carrier's frame, and a third hole allowing an additional M4 screw with nuts and washers to provide extra support at the split section. (Please refer to attached images for clarification.)\r\n\r\nTo ensure stability, consider tapping M5 into the bed carrier; if not done so, the mount may come loose over time.\r\n\r\nPair this mount with either:\r\nhttps://www.thingiverse.com/thing:460578\r\nor\r\nhttps://www.thingiverse.com/thing:1228521\r\nfor optimal compatibility with Logitech C270/C170 cameras.\r\n\r\nAfter experimenting with various models, I found that the Tevo Michelangelo's limited build area and movement significantly impacted time-lapse video quality; thus, attaching the mount to the bed carrier became necessary.\r\n\r\nTwo versions of this model were created: a longer one showcased in images and a shorter version designed for printers with smaller build areas, such as the Tevo Michelangelo. To print the latter, users should rotate the model within their slicer software.\r\n\r\nIf camera proximity remains an issue after mounting, consider acquiring an alternative lens.\r\n\r\nA minor adjustment was made to the camera's mount height, which is now 10mm lower than previously used; users can refer to attached images for further clarification on this modification.\r\n\r\nWhen printing infill, some vibration may occur due to inherent mechanical constraints.\r\n\r\nTo view a time-lapse video of this setup in action, visit:\r\nhttps://www.youtube.com/watch?v=ES4OM_K_tWw