Tevo Little Monster Mechanical Endstop Mount

thingiverse

I designed this endstop around the switches that were readily available, then worked to optimize the mount to achieve maximum Z height. To accomplish this, I utilize the common and NO terminals - the two closest to the base of the switch arm - positioning the switch so those terminals fit snugly into the cutout in the top plate. To make each endstop work, you'll need: - 2 M3 drop-in t-nuts - 2 M3x6mm socket head cap screws for the t-nuts - 2 M3x6mm or M3x8mm to attach the switch to the printed part - cable and connectors to wire it up - endstop You'll also have to clip off the NC terminal, as it would otherwise collide with the top plate. After swapping out the endstops, you'll need to change the configuration to invert the endstop logic (NO vs. NC). I didn't need to remove the grub screws from the carriages. However, if you plan on using these stops permanently, I recommend doing so for aesthetics and the risk of them becoming loose and getting caught up in the switch.