Tevo Little Monster Glass Borosilicate Glass Base Clamps

thingiverse

I have Borosilicate glass that I use over the base of my Tevo Little Monster for printing most materials, and it has a textured surface on the other side for printing PETG. However, the glass clamps I found online were designed for 16" table glass, which is what I used previously, and they weren't adjustable or sized for 348mm round sheets of glass that I was switching to. So I set out to design these clamps that would allow me to apply tension to the ~3mm thick Borosilicate glass while avoiding my very low part cooling blower that surrounds my hot end. This way, I could easily release the tension on one piece and flip the glass to the textured/sticker side as needed. After a few iterations and tests, I found these clamps to be quick and easy to print and work flawlessly. You can print and install more than 3, but at least 3 seem to function optimally.