Tevo Little Monster Chimera Effector

thingiverse

Replacement effector designed for use with a Tevo Little Monster, suitable as a chimera or cyclops configuration. After printing, tap the holes to mount the delta arms using an M4 tap. Print with low layer height and interior perimeters preceding exterior perimeters to eliminate the need for supports. A mounting point for the BL Touch sensor is absent; instead, FSRs have been employed: https://www.thingiverse.com/thing:2785213 Aside from disliking the BL Touch, the use of FSRs enables bed leveling to account for any effector tilt. To achieve level nozzles, follow this procedure: Mount heater blocks fully inserted into heatsinks and secure with grub screws. Run the calibration sequence. Enter G30 Z0. Adjust height until a piece of paper barely clears both nozzles. Loosen grub screws and slide paper to ensure equal nozzle engagement. Tighten grub screws and rerun the calibration. The Openscad source code is available: https://github.com/crpalmer/scad/blob/master/tlm-effectors.scad