TEVO C270 Camera Mount

thingiverse

I created a new mount that raises the camera 60mm higher, and you can check it out here - https://www.thingiverse.com/thing:2457855 This is a quick Logitech C270 camera mount I made for my Tevo Tarantula running on OctoPrint. I wanted something to pose the camera without designing a ball/socket setup, which seemed too much work. This will likely hold better in the long run anyway. It mounts on the left Z plate (original Tevo acrylic) and uses the two screws that hold the toothless pulleys. I was able to fit it with the existing screws. You'll also need an M4 x 10mm (or close) to assemble the camera bracket to the mount, as well as an M3 x 16 or longer to attach the camera to the bracket. It might work with other models that have a similar camera housing. The hinge on this Logitech camera is 6mm wide and fits a 3mm pin, which could be helpful. You'll need to remove the existing clamp from the Logitech camera so all you're left with is the lens housing. Once it's on, you can adjust the pan and tilt and tighten it down into place. You might also want to focus the camera (requires some hacking). Here's how to do it - https://tamarintech.com/article/ciclop_scanner_focus_fix