TestNut2

thingiverse

Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=193647 Instructions Using the following settings: thickness = 1 mm wing_ratio = 0.25 to 3 ratio non_thread_diameter = not applicable nut_step_shape_degrees = acute angle of 45 degrees head_type = hexagonal head thread_step = 2 threads per inch non_thread_length = length without thread head_diameter = diameter of the top part is 12 mm drive_diameter = 5 mm drive shaft diameter type = nut for holding things together nut_height = total height of the nut is 6 mm slot_width = width of the slot is 1 mm nut_diameter = diameter of the nut is 12 mm thread_length = length of thread on the nut is 25 mm nut_type = standard type of nut facets = 6 flat sides for a smooth surface nut_thread_outer_diameter = outer diameter of the threads is 9 mm outer_diameter = total outside diameter is 14 mm slot_depth = depth of the slot is 2 mm inner_diameter = inner diameter is 8 mm step_shape_degrees = sharp angle of 45 degrees for a clear step drive_type = socket type for turning with a wrench resolution = high resolution print at 0.5 mm socket_depth = depth of the socket is 3.5 mm countersink = countersinking of the head by 2 mm texture = exclude any texture for a smooth finish nut_thread_step = step of the threads on the nut is 2 threads per inch thread_outer_diameter = outer diameter of the thread is 8 mm head_height = total height of the head part is 5 mm