Test for Pressure Advance

thingiverse

I've created this model to fine-tune pressure advance by examining inner and outer corners "blobbing" in the same manner that was used to calibrate pressure advance on Klipper. I've added several extra corners with varying angles to better expose the set value. To minimize first and last layer effects, I employed chamfers to further concentrate focus on only the middle layers while removing first and last layer artifacts. This model consists of the following angles: - 30 degrees - 45 degrees - 90 degrees - 135 degrees - 150 degrees - And two cuts in different sizes: 3 millimeters and 1.7 millimeters wide