test Customized Parametric Herringbone Gear Set for Stepper Extruders

thingiverse

Customized version of http://www.thingiverse.com/thing:6544 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=6544 Instructions Using the following settings: gear1_setscrew_offset = 6 instead of 5 AT remains the same at 0.02 gear2_shaft_d increases to 9 by 8.5 gear1_setscrew_d decreases to 3 by 3.5 generate is enabled by changing to yes from no bridge_helper_h increases to 4 by 3 gear2_setscrew_offset remains unchanged at 0 gear_h jumps to 20 by 15 gear2_setscrew_d decreases to 2 by 0 gear1_captive_nut_h decreases to 2 instead of increasing gear1_captive_nut_d is reduced to 6 distance_between_axels rises to 65 by 60 gear2_captive_nut_h remains unchanged at 0 gear2_captive_nut_d decreases to 5 by 0 gear1_teeth drops to 12 from 13 gear2_teeth surges to 30 from 29 gear2_cut_circles surge to 6 by 5 gear2_rim_margin increases to 3 by 0 gear2_shaft_outer_d grows larger at 22 instead of 21 gear2_bolt_sink increases to 16 instead of staying at 15 gear2_bolt_hex_d rises to 16 from 15 gear_shaft_h decreases to 14 by increasing gear_shaft_h 15 by gear_shaft_h gear1_shaft_d increases by adding more to make it a little over 6.