test 16

thingiverse

Instructions Using the following settings: nidler = Off profile = Standard m3_nut_hex = Hex no_of_nuts = One pulley_b_ht = Flat bottomed retainer_ht = No retainer idler_ht = Standard idler height additional_tooth_depth = 0.3 more than standard motor_shaft = 60mm shaft length m3_nut_depth = Deep thread depth nut_angle = Right angle nut placement m3_nut_flats = Fluted for extra grip nut_shaft_distance = 1/16 inch distance between nut and shaft teeth = 76 precise gear ratio additional_tooth_width = Increased tooth width for strength pulley_t_ht = Thicker hub with a 19mm diameter bearing seat pulley_b_dia = Diameter of pulley is zero inches due to material used retainer = Retained using existing system m3_dia = M3 bolt used throughout