Tesla Turbine Parts

pinshape

Summary This is a turbine designed by Nikola Tesla, boasting an impressive 95% efficiency rate, which I've modified to suit my needs. To seal it off completely, I plan to give the parts a protective coating using plastic dip. To operate this device safely, compressed air must flow through one of the two holes at the top, where a 1/8 inch rod passes right through both exhaust plates and the spindle – an essential component that has yet to be pictured. When handling the turbine, always wear proper safety gear. Please note that I'm not responsible for any injuries you may incur while using this device. Instructions Print two face plates. One body. One spindle. Before starting work, put on goggles and take other necessary precautions. To assemble the parts correctly, print the spindle with one flat side facing down and the body with its large face down.