Tesla Model S - Easy to print

thingiverse

This is a remix I created for the Tesla Model S. I divided the model into two halves to make it easier to print - all you need to do is glue them together. No supports are required now, not even for the side mirrors. I also cleaned up the model slightly in Meshmixer. The wheels used are identical to those in the original model. I printed four of these with the rim facing upwards. Support was necessary for these prints. In Cura, I scaled the model up by 1000%. When printing it, I used two walls, two bottom layers, and five top layers. The initial layers were printed at a speed of 10 mm/s, while the rest were printed at 60 mm/s. The infill was also printed at a rate of 200 mm/s. I will soon post pictures of the completed print.