Tesla Model 3 Mud-guards front

thingiverse

3D Printed Mud Guards for Tesla Model 3 Front Wheels. Installation is Quick and Easy, Taking Just a Few Minutes. No Drilling or Modifications Required. Print Your Parts, Smooth Out Sharp Edges and Imperfections, and Enlarge the Hole for the Push-In Clip. Rub Down Visible Areas with a 3M Scotch-Brite Pad and Plenty of Water to Achieve a Nice Matte Finish. Hardware: * 6 M3x8mm Stainless Screws (Hex Button Head or Hex Socket Head Recommended), Exactly 8mm Long * 6 Stainless M3 Nuts Tools: * Allan Key for M3 Screws * Flat Screwdriver for Tesla Push-In Rivet Installation: - Clean the Area Thoroughly, Removing Any Sand or Dirt Between Paint and Printed Parts. - Release and Remove the Tesla Plastic Push-In Rivet Using a Flat Screwdriver. - Assemble the Printed Mud Guard and Back Plate, Leaving Only a Few Threads on M3 Screws to Allow Maximum Slack Between Parts. - Carefully Slide the Mud Guard into Position, with the Back Plate Behind the Steel Lip, Keeping Some Space Between Parts. - Adjust Position as Needed. - Reinstall the Tesla Plastic Push-In Rivet. - Fine-Tune Position if Necessary. - Tighten M3 Screws.