Tesla Charger Organizer with separate logo insert and nub

thingiverse

TooMuchFun's design stands out as my absolute favorite among all Thingiverse offerings. However, numerous commenters have struggled with either fitting their charger or getting it stuck in the holder. There are various suggestions about scaling up the print, which I initially tried but found that the charger became too loose and could fall off. After carefully reading through some comments, I realized that the original design's dimensions were perfect - the issue lay in the height of the nub at the bottom of the print. Initially, I remixed the design to reduce the nub height but quickly noticed that my charger plug was getting damaged. So, I separated the nub and made it a standalone piece. This offers two options: 1. You can print the nub with TPU - I used a 95 shore hardness TPU with 10% infill and 2 walls. 2. Experiment with different nub heights to find the best fit for your charger, printer, or filament. I also separated the logo to make it easier to print in a different color. The tolerance for the nub and logo slots is 0.2mm, so you may need to add some CA glue to secure everything in place. Thanks go out to TooMuchFun for creating an excellent design.