Tesa Tape Roll remixed

thingiverse

Hi! This is a remix of the Tesa Tape Roll by ollma517 https://www.thingiverse.com/thing:2174363. I simply scaled up the roll/wheel to 26mm diameter, so it fits perfectly into the tesa-rolls. In addition, I designed a new axle with a 3.8mm thickness on the outside and a 4.8mm thickness in the inner area, fitting snugly around the roll. If you want to be extra cautious, you can glue them together; however, mine sticks perfectly without any adhesive. If it breaks again, I only need to replace the axle, which is a convenient solution! I printed both parts with no infill, but the axle would likely benefit from 100% infill for added stability. For the roll, I used an 8mm brim and no raft or brim on the wheel itself. Printing took approximately 25 minutes for the roll at 0.3mm layer height and a speed of 60mm/s. It required about 1.8 meters or 5 grams of PLA filament. The axle took around 5 minutes to print, using only 0.13 meters (or 8 minutes and 0.21 meters with 100% infill). Happy printing! I'd love to see your results!