Terrarium Minimalistic Frame

thingiverse

A minimal frame terrarium enclosure. This is a minimalistic "frame" with top, sliding door. I imaging you can even lay it so you have a front facing, pull UP door. The sizes uploaded are for 12"x12"x12" (304.8mm) and 3mm thick acrylic. However you can adjust as needed for your specific needs. Use blue painters tape to support while you set the pieces and I'm using CA glue with activator to bind them. Follow the manufacturer recommended settings for your filament or what works best for you. I used LINE supports at 50 and 20% GRID infil. Print at 60 mm/s, bed 70C, extrusion at 230C. I also used BRIM plate adhesion.This is the basic design. I'm currently developing a light bar holder for across the top so you don't have to remove the light every time you have to open it.Designed in WINDOWS 3D BUILDER and sliced with CURA.