Terrarium Lid Humidifier Attachment

thingiverse

This is a screw-on attachment I made for my ball python's terrarium. The lid is made of a fine metal mesh, and so I previously had the humidifier tube sitting on top, letting the humidity fall into the tank. More of it pooled on the lid than made it into the tank, wasting tons of distilled water. To use this print, cut a hole about 35mm in the top of your terrarium lid. Slide the "screw" part down into the lid and tighten the nut securely on the underside. Most humidifier tubes will sit inside of the "screw" part on the outside perfectly, allowing the humidity to fall into the terrarium. The underside is blocked to prevent your reptile (or whatever) from escaping into the humidifier tube, and the locking "nut" secures it tightly to the lid of the terrarium. Check out the photos to see what I'm talking about...