Terracotta storage jar with base

thingiverse

This is a modified version of http://www.thingiverse.com/thing:268347. I made an enhancement by adding a base for easier printing when the cut-off bottom reaches just 4mm (in Cura). Warning: The model flaw lies in the fact that it prints a top closure on the jar, even if there isn't one in the model, at least with Cura. Removing it was straightforward using an exacto-like knife and then sanding down the area. Printed details: Instructed print settings used were as follows: 30mm/s speed, 0.5 layer thickness, temperature between 180/190°C, and a layer height of 0.2mm. A cold glass bed treated with hairspray and a 1.5mm wall width ensured a high-quality finish.