Tensegrity Soap Dish

prusaprinters

<p>Top dish with soap is suspended in air by 5 tensioned zip ties. Using zip ties instead of strings or wires makes assembly much easier.</p><p>You will need 10 at least 100 mm long 2,5 mm zip ties.&nbsp;</p><p>Build:</p><ol><li>Cut off the locking part from 5 zip ties.&nbsp;</li><li>Mark 70 mm from the lock on 4 zip ties and run them through peripheral holes in top and then botom dish.&nbsp;</li><li>Put cut off locks on zip ties and slide them to 70 mm mark.&nbsp;</li><li>Put the center zip tie from bottom dish up. Put the lock on it and tension whole assembly through the large center hole in top dish.&nbsp;</li><li>Cut off excess zip ties.&nbsp;</li></ol><p>&nbsp;</p><p>Print with 0.2 mm layer, 100% infill, 3 perimeters, bottom dish no supports, top dish supports from build plate only.</p>