Tensegrity - Impossible Spirals

cults3d

I printed everything downscaled to 75% and used jewelry cord to connect all parts. (The blue ball is a little bit bigger.) You may need to widen the holes with a hot needle at lower scales. I recommend to not scale it down to less than 50%! I printed everything except the ball without support, but the result may be better if you print with it, when your cooling is not so good. Brim is always recommended. Edit: I added a part with a by 60° changed position of the holes. You can print 2 of one or 1 of both, depending on what you prefer. (My suggestion: If you want both parts to be closer to each other, 2 of one version would look better. If you want them a little bit further away from each other, 1 of each version would be better.)