Tensegrity Display Table

thingiverse

Added 6 more flat options with angularity and less structure (4-8). Shown minimal structure bends well when done right. 0.4mm wire works great for the job! For added effect, only wire three of the connections as shown. Don't do this for the 2-part, unconnected Flat 8 base. Keep the weight toward the non-wired side to prevent tipping. A tensegrity display table with options for top and bottom sections comes in various designs. Banana serves as a scale reference. Used 1mm craft wire for the silver model shown, but recommend finer wire or strong fishing line instead. Wire allowed for substantial strength and longevity while avoiding complicated knotting and tying of string. The print itself can be improved with setting changes to enhance quality. Arcs fit firmly into slots in each flat section. Use force to make them snap into place. For the easiest assembly, tie the centers of each arc together first, then attach one base and make ties of equal length. Tighten these well to prevent wobbling or distortion of the strings/wires when weight is added. Wires or strings extend through the structures for strength and to ease the tying process. Arcs are 8mm thick, so recommend a top/bottom thickness of 4+ mm to make them solid. All holes are 2mm in diameter with 1mm of depth on the "outside" of the parts. Use 1mm or smaller wire for optimal results. 0.4mm wire or strong fishing line enhances the illusion as long as weight is limited. Remember, most of the weight will be held by one strand. The arcs are very strong, so the string is the weak link. If holes print closed, heat a paperclip and poke through with it. It should only be a thin layer. Comment if you want CAD files. A few are messy, but they're all adaptable to your needs.