Tens Pad Keeper with wire organizer

thingiverse

When I bought my tens machine it came with a pad keeper but it has an added groove that works as a wire organizer. I remixed the plain one to have the wire keeper too. I printed this with basic settings but, in Cura, I flipped the holder 90 degrees so it's long ways vertical and the end without notches is down, notches are up top. I then printed it on a raft. The final result was smooth and shiny on both sides and a few little attachment spots clean up easy. A little blow torch worked great. Hint: you put one pad on each side, run the wires out through the “bottom” where the notches are and then wrap them around the edge. Very handy when I am using the same pads in the same setup repeatedly!