Tenere 700 T7 2019 dashboard vibration dampener reworked

thingiverse

I've reworked the design from Pihmake as the small curve on the back of the part was causing the slicer to generate a lot of supports which were later a pain in the A5S to remove. My design has the back of the part flat for the most part of its length so that no supports are required there. Also, the opening in the middle of the part of the original design was impossible to print without supports as well, which again are very hard to remove later, so I've redesigned this as well and put round holes instead, which depending on your printer's part cooling capabilities may not require any supports at all. I personally had it printed without any supports. Enjoy.